SKU:

This kit adjusts (2 Degrees) the camber of the rear wheels of your smart car and eliminates the "Overloaded Trailer" look on your smart car.

Installation Instructions
1-Remove wheel.
2-Remove brake drum.
3-Remove center bolt from end of axle.
4-Remove four (4) torx bolts that secure wheel hub, and discard (requires 3/8" drive E14 external torx socket).
5-Slip spacer on CV shaft, chamfer towards CV joint.
6-Slip wedge shim between mounting bracket, and brackin plate, note "TOP".
7-Reassemble wheel hub using supplied hardware.
8-Reassemble in reverse
9-Repeat on the other side


BMS